Campbell CS-GSM/GPRS Uživatelská příručka

Procházejte online nebo si stáhněte Uživatelská příručka pro Sítě Campbell CS-GSM/GPRS. Campbell CS-GSM/GPRS User guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 22
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
CS-GPRS
Communications Package
User Guide
Preliminary
Issued 22.7.08
Copyright
©
2008 Campbell Scientific Ltd.
CSL 796
Zobrazit stránku 0
1 2 3 4 5 6 ... 21 22

Shrnutí obsahu

Strany 1 - Communications Package

CS-GPRS Communications Package User Guide Preliminary Issued 22.7.08 Copyright © 2008 Campbell Scientific

Strany 2

CS-GPRS Communications Package 4 baud rates may be possible, depending on the modem being used, its set-up and how busy the network is locally. See

Strany 3 - Guarantee

User Guide 5 Once the port/baud rate is set you will find the main PPP settings under the Deployment, TCP/IP tab. You need to enter your username a

Strany 4

CS-GPRS Communications Package 6 Hyperterminal. The setting can also be sent from the datalogger program itself (contact CS for details of how to do

Strany 5 - Contents

User Guide 7 7. General Principles of Operation Once the PPP setting is enabled on a giving serial port the datalogger will immediately try to est

Strany 6

CS-GPRS Communications Package 8 7.2 Using systems with dynamic IP addresses If you have a dynamic IP SIM (as is standard on most networks) you will

Strany 7 - 1. Introduction to GPRS

User Guide 9 7.3 Keeping the connection open Once a connection between the logger and the Loggernet PC is established, Pakbus messaging will keep

Strany 8 - 2. Hardware

CS-GPRS Communications Package 10 every 30 minutes or set up another process, e.g. low frequency pinging, to keep the connection active. It should be

Strany 9 - 4. Datalogger firmware

User Guide 11 By implication the logger defaults to the PPPOpen state as soon a port is activated for PPP. This is not dependent on a program runni

Strany 10

CS-GPRS Communications Package 12 Note that Device Configuration program only reads these settings once when the program starts. If you wish to mon

Strany 11

User Guide 13 If the PPP link works (i.e. you get an non-zero IP address in the screen above) but you do not get a connection to Loggernet, check th

Strany 15

CAMPBELL SCIENTIFIC COMPANIES Campbell Scientific, Inc. (CSI) 815 West 1800 North Logan, Utah 84321 UNITED STATES www.campbellsci.com info@campbellsci

Strany 16 - 7.4 Firewall Issues

Guarantee This equipment is guaranteed against defects in materials and workmanship. This guarantee applies for twelve months from date of delivery. W

Strany 18

i Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab for links to spe

Strany 20

1 CS-GPRS Communications Package This manual is designed to act as an addendum to the CS-GSM manual that describes general use of the Wavecom Fastrac

Strany 21

CS-GPRS Communications Package 2 • Can do a one way transmission to Loggernet or another logger (Senddata) • Can open virtual serial ports to other

Strany 22

User Guide 3 For full flexibility specialist suppliers provide a service to give individual devices a fixed IP address, which can either be private,

Komentáře k této Příručce

Žádné komentáře