Campbell CS106 Manuál s instrukcemi stáhnout pdf (Strana 17)

CS106 Barometric Pressure Sensor

TABLE 7-1. Signal and Ground Connectors for CS106

Wire

CS106 Terminal

Datalogger

Single-Ended Measurement

Datalogger

Differential Measurement

Blue VOUT S.E. Input High Side of Diff Input

Yellow AGND

Low Side of Diff. Input

Black GND CR9000(X)

G (Other Dataloggers)

(CR9000(X)

G (Other Dataloggers)

Green EXT TRIG Control port (use to turn power

on/off)

Control port (use to turn

power on/off)

Red SUPPLY 12 Vdc 12 Vdc

Shield Shield

Improper wiring may damage the CS106 beyond repair.

7.3.2 5-pin Screw Terminal Plug Connector

The datalogger connects to the CS106 via a 5-pin screw terminal plug

connector. This connector is removable and may be replaced. The

replacement connector may come with a connector key attached to it to ensure

that the connector is plugged into the CS106 right side up (see FIGURE 7-4).

When the connector is right side up, it will easily plug into the barometer.

FIGURE 7-4. Connector key attached to 5-pin screw terminal plug

connector

A 5-pin screw terminal that is plugged in upside down

will damage the sensor—perhaps beyond repair.

WARNING

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Žádné komentáře

Campbell CS106 Manuál s instrukcemi Strana 17