Campbell RF400 Manuál stáhnout pdf (Strana 68)

Appendix D. Setting Up RF401-to-CR206(X) Communications

RF401 Setup for Example 1 (see Figure 5):

1. Since the RF401 will connect to a PC, select AutoSense or RS-232 Active

Interface.

2. Choose PakBus Aware for the Protocol.

3. Must use 9600 baud rate to communicate with a CR206(X). The baud rate

setting in the LoggerNet Setup screen must also be set to 9600.

4. Select Hop Sequence 0, which matches the CR206(X)'s hop sequence.

FIGURE D-5. DevConfig Deployment panel showing the RF401 setup

for Example 1.

5. Select Net Address 0, which matches the CR206(X)'s address.

6. The Radio Address is fixed at 0 when the Protocol is "PakBus Aware".

7. Select <2ma - 1 Sec Header for the Power Mode.

8. Select Retry Level Low.

9. Entry of a PakBus Address is disabled in DevConfig for the "PakBus

Aware" protocol.

D-6

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 125 126

Žádné komentáře

Campbell RF400 Manuál Strana 68