Campbell SC-IRDA Manuál s instrukcemi Strana 1

INSTRUCTION MANUALSC-IRDA InfraredCommunications InterfaceRevision: 6/04Copyright (c) 2003-2004Campbell Scientific, Inc.

SC-IRDA Infra-red Communications Interface64.2.1 PC200W Version 1.2 and PC208W Version 3 (or later)Both of these programs will work with the SC-IRDA

SC-IRDA Infra-red Communications Interface7data collection for dataloggers that support speeds higher than 9600 baud suchas the CR23X and CR5000 datal

SC-IRDA Infra-red Communications Interface8This is a blank page.

This is a blank page.

Campbell Scientific CompaniesCampbell Scientific, Inc. (CSI)815 West 1800 NorthLogan, Utah 84321UNITED [email protected]

Warranty and Assistance The SC-IRDA INFRARED COMMUNICATIONS INTERFACE is warranted by CAMPBELL SCIENTIFIC, INC. to be free from defects in materials a

i SC-IRDA Table of Contents PDF viewers note: These page numbers refer to the printed version of this document. Use the Adobe Acrobat® bookmarks tab

This is a blank page.

1SC-IRDA Infra-red CommunicationsInterface1. IntroductionThe SC-IRDA interface is designed to provide a wireless connection between ahand-held comput

SC-IRDA Infra-red Communications Interface22.4 Datalogger Communication ModesBaud rate (default): 9600Manually selectable baud rates: 1200, 9600, 1

SC-IRDA Infra-red Communications Interface3FIGURE 1. SC-IRDA Sensor Installed in a Standard EnclosureIf mounting the SC-IRDA in this way, you need to

SC-IRDA Infra-red Communications Interface4end, but care must be taken to ensure that the 9 way D connector is sealed ifexposed to the elements. Conta

SC-IRDA Infra-red Communications Interface54. Operating InstructionsWhichever computer system or software package is used (seebelow) in all cases the