Campbell CR800 Specifikace stáhnout pdf (Strana 290)

Section 14. PakBus Networking

14-6

Example Network – RF401 Stand-alone Router

(can replace CR800_10 - RF401 Router)

Setup Description

General If RF401 settings have changed from factory defaults, use Device Configuration

Utility to set factory defaults. Then proceed with setups below.

Active Interface

(Port)

Use Device Configuration Utility for setup.

Set to PakBus Router.

Hopping Sequence Set to 1 (same as the rest of the network).

Network Address Set to 2 (same as the rest of the network).

Radio Address Not used (leave at 0).

Retry Level Set to Medium (same as the rest of the network).

Protocol Set to PakBus Node.

PakBus Address

(PBA)

Set to 10.

(Retire CR800_10 from the network or change its PBA to avoid conflict in the

network.)

PakBus Beacon

Interval

Set to 0 (no beacons).

PakBus Allowed

Neighbors

In Device Configuration Utility connect to RF401, click on PakBus tab, and type

“20” for Allowed Neighbor under both Begin and End headers. Click on Add

Range and Apply.

PakBus Verify

Interval

Set to 60 (seconds).

Central router Not used (leave at 0).

Remove CR800_10 from the network and put the RF401 stand-alone router in

its place (with AC adapter). You should see the same PakBus Graph network

map as before.

14.2 Network Configuration Basics

The general approach to creating PakBus networks is as follows (the order in

which the steps are completed can vary):

PAKBUS NETWORK SETUP

1. Create Router / Leaf-node scheme

2. PakBus address assignments

3. Neighbor discovery setups

4. Router setups

5. Communication peripheral setups

6. LoggerNet device map creation

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 323 324

Komentáře k této Příručce

Žádné komentáře

Campbell CR800 Specifikace Strana 290

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Campbell CR800