Campbell CM10 Instalační manuál stáhnout pdf (Strana 20)

Section 2. CM6/CM10 Tripod Installation

FIGURE 2-6. Guy Wire Installation

1. Construct an assembly consisting of the top plate, wire ropes, 3 thimbles,

and 6 u-bolts.

a. Place a thimble into each of the three small holes of the top plate.

Twist each thimble slightly, as shown in Figure 2-7, to accomplish

this.

b. Thread a piece of wire rope through each of the three small top plate

holes. Double the wire rope back on itself about 8 inches. Clamp the

doubled wire with two u-bolts per wire, forming a loop. Fit the wire

loop into the thimble groove. Adjust the u-bolts as needed. Once the

thimble and wire loop are fitted together, tighten the u-bolts to secure

the clamps.

FIGURE 2-7. Thimble Twisting

2-8

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Žádné komentáře

Campbell CM10 Instalační manuál Strana 20