Campbell LWS-L Návod k obsluze Strana 47

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 72
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 46
Manual Firmware Update
JS56696,0000C13 -19-08MAY13-1/1
Manual Firmware Update
To locate the latest version of John Deere Field
Connect Gateway firmware and release notes, go
to Downloads / Updates section at StellarSupport
(http://stellarsupport.com).
Firmware update requires two files to be downloaded
from StellarSupport.
GWFRMWR.BIN
MPFILE.BIN
NOTE: Do not change file names. Files must be named
GWFRMWR.BIN and MPFILE.BIN for gateway
to recognize and install update.
Firmware Installation Instructions
1. Obtain an empty USB drive formatted for FAT32.
a. Connect USB drive to personal computer.
b. Copy firmware files to USB root directory.
2. Verify Gateway battery voltage is above 11.5 VDC.
3. Connect USB drive to USB port on Gateway.
Firmware installation begins automatically and takes
approximately 3—10 minutes.
NOTE: USB LED on Gateway blinks blue
during firmware update.
4. After installation of each file is complete
- Gateway resets.
- LEDs come on momentarily.
- Multicolored LEDs cycle through three colors.
Step 4 automatically repeats until all updates have
been installed.
5. When USB LED on Gateway blinks green, remove
USB drive.
6. GPS time source must be valid for Gateway to
recognize moisture probe(s).
To confirm valid GPS time source, press multifunction
button on Gateway. Allow up to 10 minutes for GPS
connection.
- Valid—all LEDs flash once
- Invalid—all LEDs flash three times
NOTE: If GPS time source is invalid, confirm gateway
battery voltage is above 11.5 VDC then contact
your John Deere dealer for assistance.
40-1
052813
PN=47
Zobrazit stránku 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 71 72

Komentáře k této Příručce

Žádné komentáře