Campbell AVW200 series Uživatelský manuál stáhnout pdf (Strana 2)

Using Campbell AVW2xx Vibrating Wire Interfaces – MultiLogger Application Note #21 – Page 2 of 13

Configuring the AVW2xx with CSI Device Configuration Software

Note: For proper function the CR800 FW must be v8 or higher, for the CR1000 v17 or higher.

The first step is getting familiar with the Device Configuration software and the settings of the AVW2xx. It

is very straight-forward to configure the unit for the wired or wireless deployments. The Device

Configuration software is included with LoggerNet or may be downloaded from the Campbell Scientific

website at http://www.campbellsci.com/downloads

Follow these steps:

1. Connect a 12V power supply to the AVW2xx, either using an AC Adaptor or the CR800 /CR1000

12V & G connections on the wiring panel.

2. Connect a standard RS-232 cable between the AVW2xx RS-232 port and the computers COM

port.

3. Launch the Device Configuration software. The AVW2xx is the first device in the Device Type list

so it will display by default when launching the software.

4. Press the Connect button to connect to the AVW2xx.

If you receive the error shown at right then check

connections and try again.

1 2 3 4 5 6 7 ... 12 13

Žádné komentáře

Campbell AVW200 series Uživatelský manuál Strana 2