Campbell AVW200 series Uživatelský manuál stáhnout pdf (Strana 3)

Using Campbell AVW2xx Vibrating Wire Interfaces – MultiLogger Application Note #21 – Page 3 of 13

Once connected you will see a main tab control, then a secondary tab control on the main

Deployment tab. The secondary tabs, Communications and Measurements are used for

configuring the AVW2xx.

See the AVW200 Operators Manual for information on the other tabs of the main tab control.

Note: For the AVW200 (non-wireless) the radio settings will be disabled.

The following are the main settings for configuring wired or wireless deployments:

Wired Deployments

• PakBus Address

• SDI-12 Address (found on Measurements tab – set to 0)

• Multiplexer Type (if using multiplexers – found on Measurements tab)

Wireless Deployments

• PakBus Address

• Multiplexer Type (if using multiplexers – found on Measurements tab)

• Hop Sequence

• Radio Address

• Power Mode

Note: For wireless deployments make sure the Hop Sequence, Net Address and Power Mode

match the RF4xx being used for communication with the AVW2xx.

If settings are changed press the Apply button to update the AVW2xx, otherwise press Disconnect.

A summary report will display, this can be saved as an XML file for updating other units or printed for

record keeping.

See the following section on configuring the RF4xx radio for wireless deployments.

1 2 3 4 5 6 7 8 ... 12 13

Žádné komentáře

Campbell AVW200 series Uživatelský manuál Strana 3