Campbell CM10K Specifikace stáhnout pdf (Strana 19)

2. Install the memory card adaptor to the data logger: The memory card module is a

flattened box labeled CFM100. Plug it into the peripheral port of the data logger and

fasten the outside screw to secure it.

3. Insert a memory card into the CFM100: Unfasten the screw on the right hand side of

the CFM100 to open the door to the memory card compartment. Insert the special

memory card provided (regular memory cards will NOT work) in the slot. Close the

door to the compartment and tighten the screw.

4. Install the PC200W Campbell Software in your computer: This software is included

in a CD that came with the data logger and allows you to set the clock of the data logger

and upload the standard TEAM data collection program. Alternatively, if the CD is lost,

PC200W is also available on the Campbell Scientific website at:

http://www.campbellsci.com/pc200w.

5. Open the PC200W software: The data logger should now be on and waiting for

instructions on what to do. Launch the PC200W Campbell Software. Your screen will

look like Figure 7 below.

Figure 7: Main screen of PC200W software.

6. Connect the Data Logger to a Battery: Any battery that is 12 V DC can be used (e.g. a

car battery). Run two cables coming from the positive and negative poles of the battery

and connect them to the POWER IN12V and G notches in the data logger.

IMPORTANT: Connect the positive pole of the battery to the 12V notch in the data

logger and the negative pole to the G notch.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 94 95

Žádné komentáře

Campbell CM10K Specifikace Strana 19